
General
© ekey biometric systems GmbH Operating instructions ekey home Page 13 / 41
7.3
OPTICAL SIGNALS ON THE EKEY HOME FINGER SCANNER
Your ekey home finger scanner is equipped with LEDs that deliver information on the operational state
and individual functions of your system. The optical signaling of the individual finger scanners will differ
though. The two tables below will show you the corresponding signals and their meanings.
The LEDs are named based on their purpose as
Status LED – for details on the operational state (finger recognized, finger rejected, etc.)
Function LED– for details on the function of the system (online, offline, etc.)
LED signals on ekey home FS OM, ekey home FS IN 2.0 and ekey home FS WM 2.0
ekey home FS OM
ekey home FS IN 2.0
ekey home FS WM 2.0
Function
LED
Status LED Description
Normal mode
ORANGE
flashing
slow
Left: OFF
Right: OFF
There is no bus connection to the ekey
home control panel. Please check
the connection cables or apply „Initializing the devices“ as described in
section 8.2.1.4 or 8.2.2.3.
BLUE
Left: OFF
Right: OFF
The system is online – all components are communicating correctly.
ORANGE
flashing
quick
Left: OFF
Right: OFF
Once you have drawn your finger over the sensor, the system will start
the processing (enrollment) and matching. The LED flashes orange
during the entire process.
GREEN
Left: OFF
Right: OFF
Fingerprint recognition: positive, the relay switches.
RED
Left: OFF
Right: OFF
Fingerprint recognition: negative or poor image, whic h does not allow
any fingerprint check.
ORANGE
Left: OFF
Right:OFF
Fingerprint enrollment mode. When enrolling a finger via the menu on
the control panel, this LED state indicates the system to be ready for
swiping a finger over the sensor. The system generates a reference
template from this fingerprint image.
Function LED
Comentarios a estos manuales