Subject to optical and technical changes without notice; No liability assumed for setting and printing errors.
ekey TOCA Solution - F1.doc
Call (941) 782-1227 or visit www.ekeyUSA.com
Page
12
QTY Description Picture
1 per
control
unit
Fingerprint Scanner - (used for authentication only)
Is an outside unit that should be installed in a location that is
visible and easy accessible to users.
The unit is spray-waterproof, and as such the mounting location
should provide adequate protection against heavy rain, snow
showers, and intense sunshine exposure.
To ensure proper operation of the fingerprint Scanner, it should be
installed at the proper height from the ground to the upper edge of
the Scanner (53” for standard scanner; 62” for inetgra scanner).
The fingerprint scanner is connected to the control unit by 4
conductors (2 data and 2 power). Data and power conductors
should not be run in the same cable. Please refer to the wiring
diagram for more info.
Scanner is available in black that is actually anthracite color. Also,
white color Scanner is available as special order only.
1 per
system…
more
systems
can be
added as
needed
Control Unit – (used for relay control)
Is an inside unit that is installed away in a separate location
preventing tampering.
The control unit provides 3 contact closures each through normal
open/close relay.
Each of the three relays is
Controlled by different finger that is assigned during the
enrollment process. This allows a single scanner to control all
relays.
Possible to name and adjust opening time.
If needed and depending on the application specifics, each
relay can be controlled by and have separate scanner provided
the user is aware of which finger needs to swipe on which
scanner.
Each relay can be connected to any electrical device or lock such
as door strike, magnetic lock, garage door, etc. (note: these are
acquired separately and not supplied by ekey
®
TOCA system)
control unit with
different housing
1 per
system
Power Supply –
The system is shipped with a 9 VAC power supply
Power is applied to the Control Unit (inside unit).
Fingerprint Scanner (outside unit) is powered by the control Unit
(inside unit) using 2 conductors cable. Data and power conductors
should not be run in the same cable. Please refer to the wiring
diagram for more info.
If battery operation is desired, the system can operate on
regulated 12 VDC. Such 12 VDC is to be supplied separately.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales