EKey Fingerscan Access Control System Instrucciones de operaciones descargar pdf (Pagina 33)

General

8.2.2.8

CHANGING THE RELAY SWITCHING TIMES

The switching impulse times of the individual relays can be variably adjusted from 0.5s to 99.0s with

intervals of 0.5s. This enables you to adjust the duration of the opening impulse of the door according to

your application. The relay on your ekey home CP DRM is preset at

s impulse duration.

Special feature relay time 00.0

If the value 00.0 is assigned to a relay in this menu, then a special function is enabled. In this case the

relay output will toggle. Once a finger is recognized, the relay changes to its switched status and remains

there until another finger is recognized. That relay thereby works as a switch and does not emit an

impulse.

If there is a power cut or a RESET on the ekey home FS or on the ekey home CP due to a trouble

signal in this operating mode (relay permanently closed), then the relay always restarts in the

status you selected once the power supply has been reconnected (or after the reset). With the

ZnR … status after reset

flag, you define:

-… the relay always stays open after a reset or power cut

I … the relay takes after the reset of power cut the same state again as the one it had

before.

The ZnR flag can only be modified if relay time 00.0 has been previously selected!

1.)

First enter the security code as per section 8.2.2.4.

2.)

Select “Set relay time” in the main menu using the buttons.

3.)

Press the button.

4.)

Set the relay time for relay 1.

Set the relay time using the buttons. The switching impulse times of the individual relays

can be variably adjusted from 00.5s to 99.0s with intervals of 0.5s. Relay time 00.0 enables a

special feature, where the relay toggles (switch mode).

5.)

Press the button.

6.)

Set the relay time for relay 2.

DISPLA Y Enter security

code

DISPLA Y KEY

STROKE

DISPLA Y KEY

STROKE

DISPLA Y KEY

STROKE

DISPLA Y

Enter

security

code

Select the menu

item „Set relay

time“

Set relay time 1

Set relay time 2

START

ZnR ... status after reset;

Can only be modified if

relay time 00.00 (toggle

mode) has been selected.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 39 40 41

Comentarios a estos manuales

Sin comentarios

EKey Fingerscan Access Control System Instrucciones de operaciones Pagina 33

Comentarios a estos manuales

Relacionado con productos y manuales para Cámaras De Seguridad EKey Fingerscan Access Control System